NC750XA/XD

Instruments

Do not operate the display functions for a long time with the engine stopped. It may result in a low (or dead) battery.

  • Status bar
  • Selectable area
  • INFO area /Pop-up information
  • Gear position indicator area
  • Fuel gauge
  • Speedometer/Tachometer/Riding mode/Parking brake indicator/ECO indicator area


    • The meter has three display types.

    The display and arrangement change depending on each display type.

    Initial setting is BAR.

  • Tachometer is available when display type is BAR or CIRCLE.

    • To change the display type:


    Display type: CIRCLE

  • Tachometer
  • Speedometer
  • Selectable area
  • INFO area/Pop-up information
  • Gear position indicator


    • Display type: SIMPLE

  • Speedometer
  • Selectable area
  • INFO area/Pop-up information
  • Gear position indicator


    • Status bar

  • Status icons

    • Displays the Honda RoadSync status.

  • High beam indicator
  • Warning indicator

    • Comes on when your vehicle has warning information.

    Also it is displayed as pop-up information in the INFO area.

  • Clock (12-hour or 24-hour display)
    To set the clock:


    • Speedometer/Tachometer/Riding mode/Parking brake indicator/ECO indicator area

    Display type: BAR

  • Tachometer red zone
    (excessive engine rpm range)
  • Speedometer
  • ECO indicator
  • Parking brake indicator

    • NC750XD

    Lights as a reminder that you have not released the parking brake lever.

  • Riding mode

    • Displays current riding mode.

  • Tachometer

    • Tachometer is available when display type is BAR or CIRCLE.

    The tachometer colour changes when the engine revolutions exceed the set value of SHIFT POINT.

    You can turn on/off this function.

    SHIFT POINT setting:

    DISPLAY TYPE setting:

    NOTICE

    Do not operate the engine in the tachometer red zone. Excessive engine speed can adversely affect engine life.


    Gear position indicator

    NC750XA

    The gear position is shown in the gear position indicator.

  • “-” appears when the transmission is not shifted properly.


    • NC750XD

    The gear position is shown in the gear position indicator.

    The indicator may flash if:

  • The front wheel leaves the ground.
  • You turn the wheel while the vehicle is upright on the stand.

    • This is normal. To operate the system again, turn the ignition switch to the (Off) position, and then to the (On) position again.


    ECO indicator

    The ECO indicator comes on according to the fuel mileage.

    When the fuel consumption is improved, ECO indicator comes on.

  • The ECO indicator is not displayed at speeds below approximately 20 km/h (12 mph).
  • When the riding mode is set to SPORTS, USER 1 or USER 2, the ECO indicator is not displayed even if the ECO indicator is set to on.

    • To set the ECO indicator


    Fuel gauge

    Remaining fuel when only 1st (E) segment starts flashing: approximately 3.0 L (0.79 US gal, 0.66 Imp gal)

  • If the fuel gauge indicator flashes in a repeat pattern or turns off:

    • NOTICE

    You should refuel when the reading approaches the 1st (E) segment. Running out of fuel can cause the engine to misfire, damaging the catalytic converter.

    Recommended topic(s)

  • Indicators
  • Setting mode
  • Switches