Riding mode

You can change the riding mode.

The riding mode consists of the following parameters.

P: Engine output level

EB: Engine brake level

T: Torque control level

Current riding mode P level (Engine power output level) EB level (Engine brake level) T level (Torque control level)

Riding mode has five modes.

Available riding modes: [STANDARD], [SPORT], [RAIN], [USER1], and [USER2].

In following three riding modes, you cannot change initial setting level.

[STANDARD] : Standard, all-round mode for a variety of situations.

[SPORT] : This mode is suitable for sports riding. You can feel the higher engine response compared to STANDARD.

[RAIN] : Good for stable riding on slippery surfaces such as rainy conditions.

[USER1]/[USER2]

Each initial setting level can be changed.

P level (Engine power output level)

P level has three setting levels.
Available setting range: 1 to 3

Level 1 has the least power.

Level 3 has the most power.

EB level (Engine brake level)

EB level has three setting levels.
Available setting range: 1 to 3

Level 1 has the weakest engine braking effect.

Level 3 has the strongest engine braking effect.

T level (Torque control level)

T level has three setting levels or can be turned off.
Available setting range: 0 to 3

Level 1 is the minimum Torque Control level.

Level 3 is the maximum Torque Control level.

Level 0 deactivates the Torque Control.

If you turn the ignition switch to the (Off) position while T level is 0, the setting is not maintained. The setting will be changed to level 1.

Selecting the riding mode

You can change the riding mode using the MODE switch.

Stop the vehicle.

Press the MODE switch with the throttle fully closed.

MODE switch

Press the MODE switch SPORT STANDARD RAIN USER1 USER2

Setting the riding mode

You can change the P, EB, and T levels on the [USER1] and [USER2] of the riding mode.

Stop the vehicle.

Select the [USER1] or [USER2] riding mode.

Press and hold the MODE switch.

Select the parameter using the or on the sel switch and shift to setting display using the on the sel switch.

Parameter

Select the setting level using the or on the sel switch.

T level can be changed to 0 (off) by pressing and holding the of the sel switch while selecting the T parameter.

Setting level

Press and hold the MODE switch until setting display closes.

You can also change the [USER1] and [USER2] settings in setting mode.

RIDING MODE setting:

Recommended topic(s)
Setting mode
Multi-information display
Checking the Coolant