CB1000/SP

Instruments

Do not operate the display functions for a long time with the engine stopped. It may result in a low (or dead) battery.

  • Speedometer/Tachometer/Riding mode/Side stand indicator area
  • Status bar
  • Selectable area
  • INFO area /Pop-up information
  • Gear position indicator area
  • FUEL/RANGE area


    • The meter has three display types.

    The display and arrangement change depending on each display type.

    Initial setting is BAR.

  • Tachometer is available when display type is BAR or CIRCLE.

    • To change the display type:


    Display type: CIRCLE

  • Riding mode
  • Tachometer
  • Selectable area
  • INFO area/Pop-up information
  • Speedometer
  • Side stand indicator
  • Fuel gauge
  • Gear position indicator


    • Display type: SIMPLE

  • Riding mode
  • Speedometer
  • Selectable area
  • INFO area/Pop-up information
  • Side stand indicator
  • Fuel gauge
  • Gear position indicator


    • Status bar

  • Status icons
    ED type

    • Displays the Honda RoadSync status.

  • High beam indicator
  • Warning indicator

    • Comes on when your vehicle has warning information.

    Also it is displayed as pop-up information in the INFO area.

  • Clock (12-hour or 24-hour display)
    To set the clock:


    • Speedometer/Tachometer/Riding mode/Side stand indicator area


    Display type: BAR

  • Tachometer

    • Tachometer is available when display type is BAR or CIRCLE.

    The tachometer colour changes when the engine revolutions exceed the set value of SHIFT POINT.

    You can turn on/off this function.

    SHIFT POINT setting:

    DISPLAY TYPE setting:

    NOTICE

    Do not operate the engine in the tachometer red zone. Excessive engine speed can adversely affect engine life.

  • Tachometer red zone
    (excessive engine rpm range)
  • Speedometer
  • Side stand indicator

    • Comes on when the side stand is down.

  • Riding mode

    • Displays current riding mode.


    Gear position indicator area

  • Gear position indicator

    • The gear position is shown in the gear position indicator.

  • “-” appears when the transmission is not shifted properly.
  • Quick shifter indicator
    CB1000SP

    • No display : Quick Shifter system is disabled.

    : Quick Shifter upshifting is enabled.

    : Quick Shifter upshifting and downshifting are both enabled.

    : Quick Shifter downshifting is enabled.

    QUICK SHIFTER:


    FUEL/RANGE area

    This area has two information.

    You can choose whether to display the FUEL (fuel gauge) or RANGE (available driving distance).

    To change the FUEL mode:


    FUEL

    When remaining fuel is below approximately 3.8 L (1.00 US gal, 0.84 Imp gal), FUEL is automatically switched to RANGE.

    If the fuel gauge indicator flashes in a repeat pattern or turns off:

    NOTICE

    You should refuel when the reading approaches the 1st (E) segment. Running out of fuel can cause the engine to misfire, damaging the catalytic converter.


    RANGE

    Displays the estimated distance you can travel on the remaining fuel.

    The indicated available driving distance is calculated based on driving conditions, and the indicated figure may not always be the actual allowable distance.


    Display range: 999 to 5 km (999 to 3 mile)

  • “mile” is for ED type only.
  • Initial display: “---” is displayed.
  • Above 999 km (mile): “999” is displayed.
  • When the available driving distance is below 5 km (3 mile) or remaining fuel is below 1.0 L (0.26 US gal, 0.22 Imp gal), “---” is displayed.


    • When “---” is displayed except for the above-mentioned cases, go to your dealer for service.

    Recommended topic(s)

  • Multi-information display
  • Setting mode
  • Shifting Gears