CB1000F

Instruments

Do not operate the display functions for a long time with the engine stopped. It may result in a low (or dead) battery.

  • Status bar
  • Selectable area
  • INFO area /Pop-up information
  • FUEL/RANGE area
  • Gear position indicator area
  • Speedometer/Tachometer/Riding mode area


    • The meter has three display types.

    The display and arrangement change depending on each display type.

    Initial setting is CIRCLE.

  • Tachometer is available when display type is BAR or CIRCLE.

    • To change the display type:


    Display type: BAR

  • Tachometer
  • Selectable area
  • Speedometer
  • INFO area/Pop-up information
  • Fuel gauge
  • Gear position indicator
  • Riding mode


    • Display type: SIMPLE

  • Speedometer
  • Selectable area
  • INFO area/Pop-up information
  • Fuel gauge
  • Gear position indicator
  • Riding mode


    • Status bar

  • Status icons

    • Displays the Honda RoadSync status.

  • High beam indicator
  • Warning indicator

    • Comes on when your vehicle has warning information.

    Also it is displayed as pop-up information in the INFO area.

  • Clock (12-hour or 24-hour display)

    • To set the clock:


    Speedometer/Tachometer/Riding mode area

    Display type: CIRCLE

  • Speedometer
  • Tachometer red zone

    • (excessive engine rpm range)

  • Riding mode

    • Displays current riding mode.

  • Tachometer

    • Tachometer is available when display type is BAR or CIRCLE.

    The tachometer colour changes when the engine revolutions exceed the set value of SHIFT POINT.

    You can turn on/off this function.

    SHIFT POINT setting:

    DISPLAY TYPE setting:

    NOTICE

    Do not operate the engine in the tachometer red zone. Excessive engine speed can adversely affect engine life.


    Gear position indicator area

  • Gear position indicator

    • The gear position is shown in the gear position indicator.

  • “-” appears when the transmission is not shifted properly.


    • FUEL/RANGE area

    This area has two information.

    You can choose whether to display the FUEL (fuel gauge) or RANGE (available driving distance).

    To change the FUEL mode:


    FUEL

    When remaining fuel is below approximately 3.0 L (0.79 US gal, 0.66 Imp gal), FUEL is automatically switched to RANGE.

    If the fuel gauge indicator flashes in a repeat pattern or turns off:

    NOTICE

    You should refuel when the reading approaches the 1st (E) segment. Running out of fuel can cause the engine to misfire, damaging the catalytic converter.


    RANGE

    Displays the estimated distance you can travel on the remaining fuel.

    The indicated available driving distance is calculated based on driving conditions, and the indicated figure may not always be the actual allowable distance.


    Display range: 999 to 5 km (999 to 3 mile)

  • Initial display: “---” is displayed.
  • Above 999 km (mile): “999” is displayed.
  • When the available driving distance is below 5 km (3 mile) or remaining fuel is below 1.0 L (0.26 US gal, 0.22 Imp gal), “---” is displayed.


    • When “---” is displayed except for the above-mentioned cases, go to your dealer for service.

    Recommended topic(s)

  • Multi-information display
  • Setting mode
  • Indicators