TRANSALP (XL750)

Switches

  • Left handlebar switch
  • Ignition Switch

    • Switches the electrical system on/off, locks the steering.

  • Key can be removed when in the (Off) or (Lock) position.

    • Locks steering.

    (Lock)

    Turns engine off.

    Turns electrical system on for starting/riding.

    (On)

    (Off)

  • Engine stop switch/ Start button

    • Should normally remain in the (Run) position.

  • In an emergency, switch to the (Stop) position to stop the engine.
  • Hazard switch

    • Switchable when the ignition switch is (On) position. You can turn it off regardless of ignition switch position.

  • The signals continue flashing with the ignition switch in the (Off) position or the (Lock) position after the hazard switch is on.


    • Left handlebar switches

  • Headlight dimmer switch/Passing switch
  • : High beam
  • : Low beam
  • : Flashes the high beam headlight.
  • MODE switch

    • Used to change the riding mode.

  •   Sel switch

    • Used to operate and set the display.
    Also used to operate the Honda RoadSync.
    Also used to set the riding mode.

  • Horn button
  • Turn signal switch

    • The turn signal will automatically stop when you complete the turn. (You can manually cancel the lights by pressing the switch in.) When used for a lane change, the turn signal will automatically stop in about 7 seconds or after riding 150 m (164 yards). In some cases, the timing at which the turn signal stops could be sooner or later. Always use the recommended tyres to ensure correct automatic cancellation operation.

    To enable or disable the turn signal automatic cancellation:

    Recommended topic(s)

  • Engine Stop Switch
  • Indicators
  • Overheating (High coolant temperature/warning indicators are on)