Switches

Start button

Engine stop button

Engine mode select button

Engine Mode

You can change the engine output characteristic depending on track conditions by using the engine mode select button.

PGM-FI mode 1: standard setting

PGM-FI mode 2: smooth setting (reduce throttle response from the standard setting)

PGM-FI mode 3: aggressive setting (increase throttle response from the standard setting)

Current Mode

Start the engine and push the engine mode select button with your vehicle stopped. The engine mode indicator under the engine mode select button indicates the selected mode by blinking the mode number in blue 3 times.

The engine mode indicator also indicates the currently selected mode by blinking the mode number once when the engine is started.

PGM-FI mode 1:

The blue indicator blinks once 3 times.

PGM-FI mode 2:

The blue indicator blinks twice 3 times.

PGM-FI mode 3:

The blue indicator blinks thrice 3 times.

If the engine mode indicator stays on or does not come on when it should, have your dealer check it for problems.

Mode Selection

Start the engine.

With your vehicle stopped and the throttle closed, push and hold the engine mode select button for 1 or more seconds.

Make sure that the fast idle knob is pushed in.

If the fast idle knob is pulled out, the engine mode will not change.

Release the engine mode select button. The engine mode indicator will indicate a selected mode by the number of times the indicator (blue) blinks.

Repeat steps 2 – 3 until the desired mode is indicated.

Recommended topic(s)
Indicators
Starting the Engine
HRC-Launch Control System