X-ADV (ADV750)

Switches

  • Left handlebar switch
  • Right handlebar switch
  • Ignition Switch

    • Switches the electrical system on/off, locks the steering.

  • Make sure that the Honda SMART Key is activated and enter the operating range.

    • Ignition switch knob / (Off/Lock)

    Ignition (On) switch

    Turns electrical system on for starting/riding.

    (On)

    Turns engine off.

    (Off)

    Locks steering.

    (Lock)

    Turn and hold the ignition switch knob / (Off/Lock) counterclockwise.

    Turn the ignition switch knob / (Off/Lock) counterclockwise.

    Push the ignition (On) switch.

  • Answer back button

    • This button is used to operate the answer back system.

    Answer Back System:

  • ON/OFF button

    • This button is used to activate or deactivate the Honda SMART Key system, and also to confirm the activation status.

    Left handlebar switches

  • Shift up switch (+)

    • To shift up the gear.

  • Headlight dimmer/Passing light control switch

    • : High beam

    : DRL auto or off (low beam)

    : Flashes the high beam headlight.

  • MODE switch

    • Used to change the riding mode.

  •   Sel switch

    • Used to operate and set the display.
    Also used to set the riding mode and to operate the Honda RoadSync.

  • Horn button
  • Cruise control lever

    • Push up or down to set the speed or adjust the set speed.

  • Shift down switch (-)

    • To shift down the gear.

  • Turn signal switch

    • The turn signal will automatically stop when you complete the turn. (You can manually cancel the lights by pressing the switch in.) When used for a lane change, the turn signal will automatically stop in about 7 seconds or after riding 150 m (164 yards). In some cases, the timing at which the turn signal stops could be less or more. Always use the recommended tyres to ensure correct automatic cancellation operation.

    To enable or disable the turn signal automatic cancellation:

    Right handlebar switches

  • Engine stop switch/ Start button

    • Should normally remain in the (Run) position.

  • In an emergency, switch to the (Stop) position to stop the engine.
  • N-D/M switch

    • To shift between Neutral and AT MODE or MT MODE.

  • Cruise control main switch

    • Press to activate the cruise control system.

  • Hazard switch

    • Switchable when the electrical system is on. Can be turned to off regardless of whether the electrical system is on or off.

  • The signals continue flashing with turn the electrical system is off after the hazard switch is on.

    • Recommended topic(s)

  • Shifting Gears
  • Answer Back System
  • Steering Lock