Cruise Control

The cruise control system allows you to maintain a steady speed within a specified range.

The available speed setting range and operating gears are listed below:

Available Speed setting range	50 – 160 km/h (30 - 100 mph)
Operating gear	From 3rd to 6th gear

When cruise control is on, your speed will still vary slightly, particularly when going up and down hills.

Cruise control is intended for use only on straight, uncongested highways. Do not use cruise control on city streets, winding roads, during bad weather, or at any other time when you need total control of the throttle.

3WARNING
Improper use of the cruise control can lead to a crash in which you could be seriously hurt or killed. Use the cruise control only when travelling on open highways in good weather.

To Set Cruise Control

Make sure the travelling speed and operating gear are conformed to the requirements of the system.

Any speed other than the available range will not be memorized.

Press the cruise control main switch (The cruise control display will be appeared).

Accelerate to the desired speed.

Push the cruise control lever to side (The cruise control main indicator colour will be changed ).

The current travelling speed is memorized, and then the set speed is displayed on the display.

Cruise control main indicator Cruise control display Cruise control set speed

Cruise control main switch Cruise control lever

To Change the Set Speed

To Fine Tune the Set Speed

To increase the set speed: tap the cruise control lever to side.

To decrease the set speed: tap the cruise control lever to side.

The set speed is displayed in the display.

Each quick tap (brief push and release) on either side will change your speed by 1 km/h or 1 mph (depending on the mileage meter set unit).

Any speed other than the possible setting range will not be indicated (stops at the upper or lower limit of the available speed setting range).

To Change the Set Speed Continuously

To increase the set speed: push and hold the cruise control lever to side.

The system will accelerate your vehicle automatically. When you reach the desired speed, release the cruise control lever.

If the cruise control lever is pushed and held to side continuously, the set speed indicated in the display will stop at the upper limit of the available speed setting range.

To decrease speed: push and hold the cruise control lever to side. The system will automatically slow your vehicle. When you reach the desired speed, release the cruise control lever.

If the cruise control lever is pushed and held to side continuously, the set speed indicated in the display will stop at the lower limit of the available speed setting range.

To Manually Increase the Set Speed

Use the throttle to accelerate until you reach the desired speed.

Push and release the cruise control lever to side.

Cruise control set speed is set to the travelling speed when cruise control lever is released.

To Manually Increase Vehicle Speed

Use the throttle in the normal manner to accelerate.

To return to the set speed, close the throttle and coast without applying the brakes.

The cruise system will maintain the speed you previously set.

To Cancel Cruise Control

To Disengage the System

Press the cruise control main switch (The cruise control display disappears, and the set speed will be erased from memory).

To Temporarily Disengage the System

Perform one of the following operations to disengage the system temporarily (The colour of cruise control main indicator temporarily goes off but the set speed remains in memory).

Apply the brake lever or pedal.

Rotate the throttle grip past the automatically closed position in the deceleration direction.

To resume cruise control:

If you are still travelling over 50 km/h (30 mph), push and release the cruise control lever to side.

If you are travelling under 50 km/h (30 mph), use the throttle to increase road speed above 50 km/h (30 mph), and then push and release the cruise control lever to side.

Recommended topic(s)
Switches
Instruments
Setting mode