CBR1000SP/ST

Switches

  • Ignition Switch

    • Switches the electrical system on/off, locks the steering.

  • Make sure that the Honda SMART Key is activated and enter the operating range.

    • Ignition (On) switch

    Ignition switch knob / (Off/Lock)

    Push the ignition (On) switch.

    Turn the ignition switch knob / (Off/Lock) counterclockwise.

    Turns electrical system on for starting/riding.

    Turns engine off.

    Locks steering.

    Turn and hold the ignition switch knob / (Off/Lock) counterclockwise.

    (Lock)

    (Off)

    (On)

  •    Turn signal switch

    • The turn signal will automatically stop when you complete the turn. (You can manually cancel the lights by pressing the switch in.) When used for a lane change, the turn signal will automatically stop in about 7 seconds or after riding 150 m (164 yards). In some cases, the timing at which the turn signal stops could be less or more. Always use the recommended tyres to ensure correct automatic cancellation operation.

  •    Hazard switch

    • Switchable when the electrical system is on. Can be turned to off regardless of whether the electrical system is on or off.

  • The signals continue flashing with turn the electrical system is off after the hazard switch is on.
  •    Horn button
  • Headlight dimmer switch/PASSING/LAP switch
  • : High beam
  • : Low beam
  • /LAP: Flashes the high beam headlight.

    • Also use lap timer.

  • These switches are used for operating and setting the display.
  •    Sel up switch
  • Sel left/right switch
  •    Sel down switch
  • MODE switch
  • Engine stop switch/ Start button

    • Should normally remain in the (Run) position.

  • In an emergency, switch to the (Stop) position to stop the engine.
  • ON/OFF button

    • This button is used to activate or deactivate the Honda SMART Key system and also to confirm the activation status.

  • Release button

    • This button is used to release the mechanical key.

    The mechanical key is used when refuelling or removing the rear seat.

    Avoid contact with the key whenever it extends or retracts.

    To release the mechanical key

    Press the release button to release the mechanical key.

  • Make sure to fully extend the key.

    • To retract the mechanical key

    Push the key into the key case while pressing the release button.

    Mechanical key

    Recommended topic(s)

  • Engine Stop Switch
  • Steering Lock
  • Activating the Electrical System in an Emergency