Instruments
Do not operate the display functions for a long time with the engine stopped. It may result in a low (or dead) battery.
You can change the speed and mileage, and fuel mileage meter units.
|
Comes on when the side stand is down.
|
Lights as a reminder that you have not released the parking brake lever.
Speedometer/Tachometer/INFO area/Cruise control display
Display type: BAR
(excessive engine rpm range)
NOTICE Do not operate the engine in the tachometer red zone. Excessive engine speed can adversely affect engine life. |
This meter has three display types.
The display and arrangement of speedometer, tachometer, cruise control display, and INFO area change depending on each display type.
Display type: CIRCLE
Display type: SIMPLE
|
Remaining fuel when only 1st (E) segment starts flashing: approximately 2.5 L (0.66 US gal, 0.55 Imp gal)
NOTICE You should refuel when the reading approaches the E (1st) segment. Running out of fuel can cause the engine to misfire, damaging the catalytic converter. |
Gear position indicator/ECO indicator
The gear position is shown in the gear position indicator.
The indicator may flash if:
This is normal. To operate the system again, turn the electrical system off and on again.
The ECO indicator comes on according to the fuel mileage.
When the fuel consumption is improved, ECO indicator comes on.
Status icons
Displays the status of the Honda RoadSync system.
Comes on when your vehicle has warning information.
Also displays as pop-up information in the INFO area and WARNING INFO display.
To set the clock:
Displays the ambient temperature.
Display range: -10 ºC to 50 ºC
Road heat and exhaust from another vehicle can affect the temperature reading when your vehicle speed is less than 30 km/h (19 mph). It may take several minutes for the display to be updated after the temperature reading has stabilized.
Display or hide the air temperature
Recommended topic(s) |
---|
|
|
|