Honda WN7

Switches

  • Left handlebar switch
  • Right handlebar switch
  • Power Switch

    • Switches the electrical system on/off, locks the steering.

  • Make sure that the Honda SMART Key is activated and enter the operating range.
  • If you want to turn the power switch on again after turning it off, make sure to wait until the display has finished ending animation, and the electric system has stopped before turning the power switch on again.

    • Power switch knob / (Off/Lock)

    Power (On) switch

    Turn and hold the power switch knob / (Off/Lock) counterclockwise.

    Turn the power switch knob / (Off/Lock) counterclockwise.

    Push the power (On) switch.

    Turns electrical system on for starting/riding.

    (On)

    Electrical system off.

    (Off)

    Locks steering.

    (Lock)

    Honda SMART Key

  • Answer back button

    • This button is used to operate the answer back system.

    Answer Back System:

  • ON/OFF button

    • This button is used to activate or deactivate the Honda SMART Key system, and also to confirm the activation status.

    Left handlebar switches

  • Headlight dimmer/Passing light control switch
  • : High beam
  • : DRL auto or off (low beam)
  • : Flashes the high beam headlight.
  • MODE switch

    • Used to change the riding mode.

  • Sel switch

    • Used to operate and set the display.
    Also used to set the riding mode and to operate the Honda RoadSync.

  • Horn button
  • /SET Selectable Speed Limit Assist Select lever

    • Used to operate the Selectable Speed Limit Assist.

  • R/- switch
  • Strong the deceleration power selector level.
  • Use the moving in reverse.
  • Turn signal switch

    • The turn signal will automatically stop when you complete the turn. (You can manually cancel the lights by pressing the switch in.) When used for a lane change, the turn signal will automatically stop in about 7 seconds or after riding 150 m (164 yards). In some cases, the timing at which the turn signal stops could be less or more. Always use the recommended tyres to ensure correct automatic cancellation operation.

    To enable or disable the turn signal automatic cancellation:

  • F/+ switch
  • Weak the deceleration power selector level.
  • Use the moving in forward.

    • Right handlebar switches

  • Motor stop switch/ Start button

    • Should normally remain in the (Run) position.

  • In an emergency, switch to the (Stop) position to stop the motor.
  • Hazard switch

    • Switchable when the electrical system is on. Can be turned to off regardless of whether the electrical system is on or off.

  • The signals continue flashing with turn the electrical system is off after the hazard switch is on.
  • Selectable Speed Limit Assist Select switch
  • Press to activate or deactivate the Selectable Speed Limit Assist.
  • Press and hold, accelerate beyond the Selectable Speed Limit Assist set speed value.

    • Recommended topic(s)

  • Steering Lock
  • Setting mode
  • Answer Back System