Walking Speed Mode

The walking speed mode allows you to forward or reverse of a parking space at slow speed.

Before you move the vehicle forward or reverse, make sure there are no people or obstacles in the direction of travel.

Avoid steep or uneven surfaces. The walking speed mode is designed to move the vehicle at a slow speed using the throttle. To prevent the walking speed mode overloaded, if the vehicle cannot move in forward or reverse because of obstacles or a steep pavement angle, release close the throttle once and stop the walking speed mode.

Carefully roll the vehicle to more level, unobstructed surface without obstacles, and then activate the walking speed mode again.

Stop the vehicle.

Sit astride the vehicle, in your normal riding position, with both feet on the ground.

Make sure the side stand is up.

Activate the motor.

Motor start button

To moving in forward

Press the F/+ button.

While holding the button press, the vehicle is in standby for forward.

When the vehicle is in standby for forward, “F” comes on.

To moving in Reverse

Press the R/- button.

While holding the button press, the vehicle is in standby for reverse.

When the vehicle is in standby for reverse, “R” comes on.

F/+ button R/- button

Forward "F" READY indicator

READY indicator "R" Reverse

When you are ready to forward or reverse, open the throttle slowly.

The vehicle will move in forward or in reverse slowly as long as you hold F/+ or R/- button and open the throttle.

Operating only F/+ or R/- button, the vehicle will not move in forward or reverse.

F/+ button Throttle Forward

Reverse Throttle R/- button

Guide the vehicle forward or reverse cautiously, using your legs to maintain balance.

Use extreme care to maintain balance while reversing on loose surfaces (sand, dirt, gravel) or slick pavement.

Completely, close the throttle, the vehicle will stop.

When the vehicle stops, "F or R" will appear on the display and the vehicle will enter standby mode.

When you shift from forward to reverse or reverse to forward, bring the vehicle complete stop. After you shift from forward to reverse or reverse to forward, make sure that the display is changed to the direction you want, "F" or "R".

When the high voltage battery is nearly fully charged or when the high voltage battery temperature is low, regenerative braking may not work or may be less effective.

To deactivate walking speed mode, press the motor start button, while squeezing the front brake lever or rear brake pedal. The "EXIT" indicator disappear from display, and you can ride normally.

Standby mode display "F or R" "EXIT"

Recommended topic(s)
Activating the Motor
Setting mode
Switches