Selectable Speed Limit Assist

Selectable Speed Limit Assist system allow you riding within a specified speed.

Always use Selectable Speed Limit Assist under the legal speed limit.

This function does not limit speed under all circumstances. Even if a Selectable Speed Limit Assist is set, the set value may be temporarily exceeded or the system may be unable to fully control the vehicle depending on riding conditions.

When the SOC (State Of Charge) of the high voltage battery is high, or when level of the deceleration power selector is low or disabled, the deceleration speed control may not work.

Depending on the conditions when going downhill, the system may not be able to fully limit the speed.

Always use the recommended tyres and pulleys to ensure correct Selectable Speed Limit Assist operation.

Avoid using Selectable Speed Limit Assist on downhill. The SOC of high voltage battery rises, the deceleration control may not work.

3WARNING
Selectable Speed Limit Assist has limitations. It is always your responsibility to adjust the vehicle speed to obey the actual speed limit, and safely operate the vehicle.

3WARNING
Do not turn the throttle grip more than necessary. Maintain an appropriate throttle grip position depending on the vehicle speed.

The available speed setting range is listed below:

Available Speed setting range

20 – 130 km/h (15 - 80 mph)

To Use Selectable Speed Limit Assist

Press the Selectable Speed Limit Assist switch (The Selectable Speed Limit Assist display will be appeared and mark on the display is grey).

Selectable Speed Limit Assist switch Selectable Speed Limit Assist display

Accelerate to the speed you want to set.

Make sure the travelling speed is within available speed setting range.

Push the Selectable Speed Limit Assist lever to / SET side. Then the Selectable Speed Limit Assist is activated.

The current travelling speed is set, and then the set speed is displayed on the display.

mark on the display is changed green.

Selectable Speed Limit Assist lever Set speed display mark

To use Selectable Speed Limit Assist with preset mode

You can use the Selectable Speed Limit Assist with preset mode. Before activating the Selectable Speed Limit Assist with preset mode, setting the preset speed value on setting mode is needed.

Press the Selectable Speed Limit Assist switch. The Selectable Speed Limit Assist display will be appeared.

Make sure the traveling speed is within available speed setting range.

Push the Selectable Speed Limit Assist lever to /SET. Then the Selectable Speed Limit Assist is activated.

The current traveling speed is set as set speed value and then the set speed is displayed on the display.

Press the Selectable Speed Limit Assist lever to side or /SET side. Then the Selectable Speed Limit Assist is activated with preset mode.

Pressing the Selectable Speed Limit Assist lever to side, the set speed value is set with higher speed in the preset speeds. If you have already selected maximum set speed value, set speed value is not changed to higher value when you press the lever to side.

Pressing the Selectable Speed Limit Assist lever to /SET the set speed value is set with lower speed in the preset speeds. If you have already selected minimum set speed value, set speed value is not changed to lower value when you press the lever to /SET side.

When you press and hold the Selectable Speed Limit Assist switch while riding at the set speed value, you can accelerate beyond the set speed value. The Selectable Speed Limit Assist display and green mark on the display will flash while accelerating. If you slow down below the set speed, the Selectable Speed Limit Assist will be restored.

To Cancel Selectable Speed Limit Assist

Press the Selectable Speed Limit Assist switch. The Selectable Speed Limit Assist display will be disappeared.

Recommended topic(s)
Switches
Setting mode
Instruments